Its good, but I'm sure your pictures and the description isn't good enough.
"To do This mod by the wire switching method, all you have to do is switch wires around. To take a wire out, go to the Female end of the molex connector and get your knife or flat head precision screwdriver. Push the little tabs in while simultaneously lightly pulling that particular pin out. When the tabs are pushed in, the pin will slide right out. After you take two pins out, switch their positions. When putting them back in, make sure the tabs aren't pressed in, otherwise the pins will fall out. To fix this, just get your knife and pry the tabs back the way they should be. The pins should snap into place and not be able to be pulled out when they are inserted."
^^Try explaining this with pictures.. would be A LOT easier for people to understand..
__________________
They say many things, they say.
|